MultEQ improves the performance of each speaker whether you are using 1 or 11. However, by setting speakers to Large you are missing out on the much higher filter resolution that MultEQ has in the subwoofer channel. These problems have nothing to do with content. LFE+Main is a bad setting because it overlaps the bass in the sub and speakers resulting in boomy bass.Īudyssey calibrates each speaker individually by looking at the acoustical problems it has in the room. My couch is up against a wall, what are 2 other places for 7 and. Do you recommend taping it on with masking tape or electrical tape, so it doesnt move Also, looking at the chart for mic position setup, it shows positions 7 and 8 behind couch. That way everything moves up and down in level together. Hi, I was wondering if there is a good way to set mic on tripod so it doesnt move. If you want to listen louder, just turn up the master volume. Because each speaker has different sensitivity and is at different listening distance, these numbers can vary. They are set so that all speakers in the system play at the same level. You can leave the crossover at 40 Hz as found or move it up slightly. I highly recommend setting them to Small. It looks like in your case the roll off is near 40 Hz so that's what Marantz uses as the decision point to set speakers to Large. The AVR is doing it based on the roll off found. But Audyssey is not responsible for making this choice. It doesn't matter if you are listening to music or movies. Speakers should always be set to Small if you have a subwoofer.
0 Comments
Leave a Reply. |